G-Sensor和陀螺仪方向的修改

zangcf

Gensor的文件

1. /media/ultranix/works/android/mtk/6735/5.1_sujiacan/alps/kernel-3.10/drivers/misc/mediatek/mach/mt6735/tx6735_65u_un_l1/accelerometer/mpu6050g-new/cust_acc.c

复制代码

修改成：

1. #include <linux/types.h>
   
2. #include <cust_acc.h>
   
3. #include <mach/mt_pm_ldo.h>
   
4. 
   
5. 
   
6. /*---------------------------------------------------------------------------*/
   
7. static struct acc_hw cust_acc_hw = {
   
8.     .i2c_num = 2,
   
9.     .direction = 6,
   
10.     .power_id = MT65XX_POWER_NONE,  /*!< LDO is not used */
    
11.     .power_vol= VOL_DEFAULT,        /*!< LDO is not used */
    
12.     .firlen = 0, //old value 16                /*!< don't enable low pass fileter */
    
13. };
    
14. /*---------------------------------------------------------------------------*/
    
15. struct acc_hw* get_cust_acc_hw(void)
    
16. {
    
17.     return &cust_acc_hw;
    
18. }

复制代码

陀螺仪文件：

1. /media/ultranix/works/android/mtk/6735/5.1_sujiacan/alps/kernel-3.10/drivers/misc/mediatek/mach/mt6735/tx6735_65u_un_l1/gyroscope/mpu6050gy-new/cust_gyro.c

复制代码

修改成
#include <linux/types.h>
#include <mach/mt_pm_ldo.h>
#include <cust_gyro.h>

/*---------------------------------------------------------------------------*/
static struct gyro_hw cust_gyro_hw = {
    .i2c_num = 2,
    .direction = 0,     
    .power_id = MT65XX_POWER_NONE,  /*!< LDO is not used */
    .power_vol= VOL_DEFAULT,        /*!< LDO is not used */
    .firlen = 0,                   /*!< don't enable low pass fileter */
};
/*---------------------------------------------------------------------------*/
struct gyro_hw* get_cust_gyro_hw(void)
{
    return &cust_gyro_hw;
}